MEGADRUM and FLEXIDRUM
|
• MEGADRUM Mica insulated barrel heaters • FLEXIDRUM Silicone rubber barrel heaters • Barrel Heaters Installation & Maintenance |
INSTALLATION Since heat has the tendency to move upwards in liquids, drum heaters should be installed close to the bottom of a vertical drum. Horizontal vessels should have their drum heaters installed such that the terminal box is positioned on the side. This will protect the box from overheating and maintain accessibility to the controls. The HDX model has a quick disconnect latch and trunion fastener, while the GCX model has spring loaded handles that have to be stretched to slide the heater to its proper position on the drum. The FLEXIDRUM is very flexible and will easily adhere to the drum surface. However, when a MEGADRUM is used, it is recommended to tap gently on both its rims to ensure tightness and good heat transfer. MEGADRUMs come with temperature controllers. When the pilot lamp is on, the heater is active. HDX models have bulb and capillary thermostats (250°F). GCX models have snap action bimetal temperature controllers (220°F). After an initial trial these controllers have to be set in proportion to the maximum settings and required temperature. FLEXIDRUMs come with B-200 bimetal thermostats (400°F). MEGADRUMs and FLEXIDRUMs are made for 120V or 240V power supplies. Appropriate power cords and plugs are supplied for each voltage and wattage. The power supply should be rated to handle the amperage drawn by the heater. Different liquids absorb heat at different rates so the wattage of a MEGADRUM should be selected accordingly. Since the MEGADRUM is not a sealed product, it should be used indoors and kept away from moisture and contamination. The FLEXIDRUM is moisture and chemical proof, but not waterproof. FLEXIDRUMs should always be used indoors since water can leak into their thermostat box. In general, MEGADRUMs and FLEXIDRUMs are maintenance free. A periodic check to ensure that they are securely fastened to the drum is recommended. The power cord is rated to withstand 220°F and should never come in contact with the heater. MEGADRUMs and FLEXIDRUMs should not be used on pressure tight containers, containers with explosive materials, or in explosive environments.
|
||

Copyright © 1997 Equiplast Inc. All
rights reserved. |